Thamrin Nine Tower 1

Jakarta

This project was redesigned and replaced by Autograph Tower

Height
1
Architectural:
Height is measured from the level of the lowest, significant, open-air, pedestrian entrance to the architectural top of the building, including spires, but not including antennae, signage, flag poles or other functional-technical equipment. This measurement is the most widely utilized and is employed to define the Council on Tall Buildings and Urban Habitat (CTBUH) rankings of the "World's Tallest Buildings."
333.5 m / 1,094 ft
2
Occupied:
Height is measured from the level of the lowest, significant, open-air, pedestrian entrance to the highest occupied floor within the building.
312.9 m / 1,026 ft
1 2 Thamrin Nine Tower 1
  Floors
Above Ground
The number of floors above ground should include the ground floor level and be the number of main floors above ground, including any significant mezzanine floors and major mechanical plant floors. Mechanical mezzanines should not be included if they have a significantly smaller floor area than the major floors below. Similarly, mechanical penthouses or plant rooms protruding above the general roof area should not be counted. Note: CTBUH floor counts may differ from published accounts, as it is common in some regions of the world for certain floor levels not to be included (e.g., the level 4, 14, 24, etc. in Hong Kong).
70
Below Ground
The number of floors below ground should include all major floors located below the ground floor level.
6
Height 333.5 m / 1,094 ft
Floors 70
Official Name
The current legal building name.

Thamrin Nine Tower 1

Name of Complex
A complex is a group of buildings which are designed and built as pieces of a greater development.

Thamrin Nine

Type
CTBUH collects data on two major types of tall structures: 'Buildings' and 'Telecommunications / Observation Towers.' A 'Building' is a structure where at least 50% of the height is occupied by usable floor area. A 'Telecommunications / Observation Tower' is a structure where less than 50% of the structure's height is occupied by usable floor area. Only 'Buildings' are eligible for the CTBUH 'Tallest Buildings' lists.

Building

Status
Completed
Architecturally Topped Out
Structurally Topped Out
Under Construction
Proposed
On Hold
Never Completed
Vision
Competition Entry
Canceled
Proposed Renovation
Under Renovation
Renovated
Under Demolition
Demolished

Never Completed

Country
The CTBUH follows the United Nations's definition of Country, and thus uses the lists and codes established by that organization.

Indonesia

City
The CTBUH follows the United Nations's definition of City, and thus uses the lists and codes established by that organization.

Jakarta

Address

Kota Bumi

Function
A single-function tall building is defined as one where 85% or more of its usable floor area is dedicated to a single usage. Thus a building with 90% office floor area would be said to be an "office" building, irrespective of other minor functions it may also contain.

A mixed-use tall building contains two or more functions (or uses), where each of the functions occupy a significant proportion of the tower's total space. Support areas such as car parks and mechanical plant space do not constitute mixed-use functions. Functions are denoted on CTBUH "Tallest Building" lists in descending order, e.g., "hotel/office" indicates hotel function above office function.

Hotel / Office

Structural Material
All-Steel
Both the main vertical/lateral structural elements and the floor spanning systems are constructed from steel. Note that a building of steel construction with a floor system of concrete planks or concrete slab on top of steel beams is still considered an “all-steel” structure as the concrete elements are not acting as the primary structure.

All-Concrete
Both the main vertical/lateral structural elements and the floor spanning systems are constructed from concrete which has been cast in place and utilizes steel reinforcement bars and/or steel reinforced concrete which has been precast as individual components and assembled together on-site.

All-Timber
Both the main vertical/lateral structural elements and the floor spanning systems are constructed from timber. An all-timber structure may include the use of localized non-timber connections between timber elements. Note that a building of timber construction with a floor system of concrete planks or concrete slab on top of timber beams is still considered an “all-timber” structure as the concrete elements are not acting as the primary structure.

Mixed-Structure
Utilizes distinct systems (e.g. all-steel, all-concrete, all-timber), one on top of the other. For example, a Steel Over Concrete indicates an all-steel structural system located on top of an all-concrete structural system, with the opposite true of Concrete Over Steel.

Composite
A combination of materials (e.g. steel, concrete, timber) are used together in the main structural elements. Examples include buildings which utilize: steel columns with a floor system of reinforced concrete beams; a steel frame system with a concrete core; concrete-encased steel columns; concrete-filled steel tubes; etc. Where known, the CTBUH database breaks out the materials used within a composite building’s primary structural elements.

Concrete-Steel Composite

Energy Label

BCA Green Mark Platinum

Height
Architectural
Height is measured from the level of the lowest, significant, open-air, pedestrian entrance to the architectural top of the building, including spires, but not including antennae, signage, flag poles or other functional-technical equipment. This measurement is the most widely utilized and is employed to define the Council on Tall Buildings and Urban Habitat (CTBUH) rankings of the "World's Tallest Buildings."

333.5 m / 1,094 ft

Occupied
Height is measured from the level of the lowest, significant, open-air, pedestrian entrance to the highest occupied floor within the building.
312.9 m / 1,026 ft
Observatory
271.2 m / 890 ft
Floors Above Ground
The number of floors above ground should include the ground floor level and be the number of main floors above ground, including any significant mezzanine floors and major mechanical plant floors. Mechanical mezzanines should not be included if they have a significantly smaller floor area than the major floors below. Similarly, mechanical penthouses or plant rooms protruding above the general roof area should not be counted. Note: CTBUH floor counts may differ from published accounts, as it is common in some regions of the world for certain floor levels not to be included (e.g., the level 4, 14, 24, etc. in Hong Kong).

70

Floors Below Ground
The number of floors below ground should include all major floors located below the ground floor level.

6

# of Hotel Rooms
Number of Hotel Rooms refers to the total number of hotel rooms contained within a particular building.

181

Tower GFA
Tower GFA refers to the total gross floor area within the tower footprint, not including adjoining podiums, connected buildings or other towers within the development.

186,000 m² / 2,002,087 ft²

Construction Schedule

2013

Proposed

2014

Construction Start

Architect
Design

Usually involved in the front end design, with a "typical" condition being that of a leadership role through either Schematic Design or Design Development, and then a monitoring role through the CD and CA phases.

Structural Engineer
Design

The Design Engineer is usually involved in the front end design, typically taking the leadership role in the Schematic Design and Design Development, and then a monitoring role through the CD and CA phases.

MEP Engineer
Design

The Design Engineer is usually involved in the front end design, typically taking the leadership role in the Schematic Design and Design Development, and then a monitoring role through the CD and CA phases.

Other Consultant

Other Consultant refers to other organizations which provided significant consultation services for a building project (e.g. wind consultants, environmental consultants, fire and life safety consultants, etc).

Façade

These are firms that consult on the design of a building's façade. May often be referred to as "Cladding," "Envelope," "Exterior Wall," or "Curtain Wall" Consultant, however, for consistency CTBUH uses the term "Façade Consultant" exclusively.

Fire
Traffic
Wind
Owner/Developer
PT. Putra Gaya Wahana
Architect
Design

Usually involved in the front end design, with a "typical" condition being that of a leadership role through either Schematic Design or Design Development, and then a monitoring role through the CD and CA phases.

Architect of Record

Usually takes on the balance of the architectural effort not executed by the "Design Architect," typically responsible for the construction documents, conforming to local codes, etc. May often be referred to as "Executive," "Associate," or "Local" Architect, however, for consistency CTBUH uses the term "Architect of Record" exclusively.

PT. Paramita Abirama Istasadhya
Structural Engineer
Design

The Design Engineer is usually involved in the front end design, typically taking the leadership role in the Schematic Design and Design Development, and then a monitoring role through the CD and CA phases.

Meinhardt; Wiratman
MEP Engineer
Design

The Design Engineer is usually involved in the front end design, typically taking the leadership role in the Schematic Design and Design Development, and then a monitoring role through the CD and CA phases.

Beca Group; Meinhardt; PT. Meltech
Other Consultant

Other Consultant refers to other organizations which provided significant consultation services for a building project (e.g. wind consultants, environmental consultants, fire and life safety consultants, etc).

Façade

These are firms that consult on the design of a building's façade. May often be referred to as "Cladding," "Envelope," "Exterior Wall," or "Curtain Wall" Consultant, however, for consistency CTBUH uses the term "Façade Consultant" exclusively.

Fire
Landscape
Belt Collins & Associates
Lighting
PT. LITAC
Property Management
Pan Pacific Hotels Group
Traffic
Wind

CTBUH Initiatives

 

About Thamrin Nine Tower 1

Thamrin Nine is a high-rise complex situated near one of Jakarta’s most historic and socially active venues, the Bundaran Hi Monument, and will be highly visible along the well-traveled Jalan Thamrin thoroughfare. The development is most identifiable through the juxtaposition of two paired geometric towers, the most visible of which is Tower 1, the flagship of the development. A dense retail podium links Tower 1 and Tower 2, and taken together, the buildings form an identifiable, architectural composition defined by strong cubic forms and projecting rectangular volumes.

Inspired by the nearby UOB Plaza tower, Thamrin Nine Tower 1 is meant to rise with a visual presence that stems from its height, proportion, and simple extruded surfaces. This expression is bolstered by a layered façade with “floating” silver blue glass cladding, its planar language giving depth and dynamism to the tower while unifying programmatic variation. Subtle articulation of the façade through the use of specular silver edges and horizontal fins brings a sense of scale to the tower, while also providing passive shading to the entire building. The key element of Tower 1, set against its strictly planar expression, is a prominent, cantilevered, public observation deck that hovers above an outdoor skywalk.

The building integrates a range of public and private functions within 186,000 square meters of space. At its base are restaurants, retail shops, and a two-story atrium serving the tower’s office floors, which include a penthouse zone of offices with triple-height voids connecting multi-level tenant spaces. A separate lobby serves hotel floors at the top of the tower, where a central atrium brings light and air into the interior. At the top of the tower is an open-air roof garden arranged at varying levels to distinguish the public roof deck from private hotel amenities.